Shedding

Some tool functions are only available in expert mode

This option lets you add a hole area to an existing row in just two clicks.

A hole area is a zone that specifies to the robot that it must raise its tools at this point while continuing to follow its trajectory. This makes it possible to avoid working in an area with a buried obstacle, or to draw a zone around an obstacle (pylon, well…) within a plot.

This option is only available when at least one map is loaded into the application.

When the option is launched, you can click on two points within a row to draw a relief zone between them. Holes areas appear on the row with a blue filter as shown in the following screenshot.